Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Everyone,
I've got 90+ switches running SSH and I want to (temporarily) enable http secure-server and then disable it (as well as run a few other commands).
Right now my only path into the switches is via SSH.
Rather than sit for hours doing th...
Hey everyone,
I'm looking for any 'official' Cisco documentation recommending for/ against enabling IP HTTP Secure-Server (not IP HTTP server).
I have a bunch of network switches at a customer site that need mapped and documented. They are on an in...
Hey everyone,
So I've been troubleshooting this for about the last 10 hours and have stripped my ACL's down to a bare minimum to avoid any confusion.
I have an ASA 5505 setup with a DMZ. I have a server connected to the DMZ (PC1, AKA Historian, 10.11...
Marvin,Thank you for sticking with me here - I'm learning.
I think I understand what you are saying - I actually did intended to tighten up the ACL once I got things working. So right now, here's a screenshot of what I've got.
When you say I should ...
Marvin,
I guess I never knew that! Learn something new every day. What's the typical methodology for dealing with that then? I really don't want to leave all those ports open between my DMZ and my inside - is there a workaround, or do most people ...
Update:
Marvin,
It seems I have answered my own question #2. (Still a bit confused on #1). For some reason RDP was trying to initiate the connection from a random port (not sure why.) When I tried ssh through it was successful. So, in short, the ...
Marvin,
Thanks so much for the reply (I have read many of your replies on the forum and you are always super helpful.)
I deleted those interfaces and have changed the port mode from trunk to access on the ASA (and assigned it as access VLAN 15). I d...
