Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I wonder if you can help me. I currently have two sites, Site A and Site B that both sit behind a Meraki and a Cisco FPR1120 Firewall. The Meraki establishes a site to site vpn tunnel between the two. Site A details: inside network 192.168.1.0/24...
Hi, I currently have two offices/networks connected to one another via Cisco Meraki Site to Site VPN. Office A has network address 192.168.1.0/24 and Office B has network address 192.168.2.0/24. Office B also has a Cisco FPR1120 firewall managed thro...
Hi all,Running a FPR1120 Firepower FDM and have set up a remote access vpn tunnel with Cisco AnyConnect. Tunnel connects fine and I can access internal resources but no external internet. Need to maintain a full tunnel (no split tunnelling) and belie...
Hi all, I currently have a setup as follows: ISP - Edgerouter Lite - Cisco FPR1120 - Internal Network I have set up a test network for testing the Remote Access VPN setup using Anyconnect Plus. Edgerouter Lite has an ip of 192.168.1.1, outside interf...
Have updated the NAT rule to the following: but no luck. Re interesting traffic we're using the Meraki AutoVPN technology and there is a static route specified, not sure if there's additional specific setting we need to look at adding? Thanks,
Hi, Following up on the above thread as I still haven’t managed to get web filters working on the remote access vpn pool. I have an ACP block rule that currently has source as inside, network vpnpool, destination outside with a list of url categories...
So I’ve added a ACP as follows: Name RAVPNFilter, Action Block, Source Zone Outside Zone, Network VPNPool, Destination Zone OutsideZone, then a list of applications/url categories for blocking. Couldnt get this to work though. I’ve tried changing sou...
DTLS was disabled, enabling it solved it, thank you. Last one from me, is there a way for the URL filtering policies to be applied to the Remote Access VPN users? Thanks,
