Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've built a lab with two standalone ASA with no failover unit in firewall router and multiple context mode with failover active setup on each to make them act as primary and to simulate two separate Data Centers and DMZs. When I d...
I have a asa5520-k8 with 7.2(4) that I found an NAT that was missing but before I can enter it I had run two commands below in order to enter it and I need to understand why if the xlate entry did not exist.. no alias (inside) 10....
We are migrating DMZ segments from a checkpoint to a ASA 5585 firewall that we had connected to the same segments as the Checkpoint except on different IP addresses then the checkpoint interfaces. The Checkpoint interfaces are the default gateway for...
I have a question that I hope someone can clarify ... I will be supporting a new ASA 5585X running 8.4 and I was wondering if it's possible to apply an ACL globally instead of it as an access group that is applied to a specific interface as in or out...
I have a customer that ordered the WCS application, a 5508 WLC and (38) 1142 APs. Does anyone have a form that I can give to the customer to fill out as a guide to help with the installation and configuration which he can fill in the information need...
Sorry the alias (inside) 10.120.208.26 172.27.208.26 255.255.255.255 did exist but I noticed that it was not working and to fix it I had to run the two commands to get the NAT to work again .. Need to know if this is a bug or correct way to fix a tr...
Jouni , Thank you for the information which I will suggest them to add it .. Yes , this is a completed product migration from IPSO checkpoint NGXR65 to ASA5585X Version 8.4(3) .. I believe the reasoning behind using it as global was tha...
