Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can someone please confirm if I am thinking along the right lines?I want to capture traffic on 6500a vlan 333 and sent it to 6500B which has an IDSM blade.Is this all I need to do?(coss-over) cable from 6500a to 6500bCreate remote span vlan 444 on...
Hi All,I really need some advise here. I have 20 sensing points. Hope to limit 1 sensing point to 100MB. What model of CSMARS would you recommend?I am thinking about the CSMARS 100e-k9? Thanks in advance.
Hi All,Can 802.1q be used for monitoring with IDS? is so can someone guide me as to how it works and how its configured.I have been searching for more information to no avail.. please help.
Hi,Can someone please confirm if the ASA 5500 series IPS edition appliance also runs IDS? Also does it have major limitations compared to a stand-alone 4200 series IDS?Thanks in advance.
Hi,I was told by Cisco that they will have no support for the ASA via VMS. Cisco are trying to push everyone to the all singing and dancing CSM!-Ciscobloke
Guys I want to say thank you for your advice.I was counting a port on the 4250XL as one sensing point.However I am going more towards the idea of using the IDSM-2s on the 6506s.Use RSPAN on the external switches to the ethernet line card on the 6506 ...
marcabal.I just want to say thank you very much for you prompt answer. It answers my question for sure..... thanks.One more question, how limited are the IDS network modules that plug into routers? for example are the number of signatures limited?Tha...
