Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Controllers are in Internet.There are 2 x cedges in DC. 1 x MPLS on MPLS cedge and 1 x Internet on INET cedge .There are 2 x cedges in each Branch.1 x MPLS circuit on MPLS cedge and 1 x Internet circuit on INET cedge .TLOC Extension works for connec...
There is no NAT related config on ACE, so I believe that load balance is not using source translation.On the backbone, there is route-map configured on the Server vlan. This route-map is used for "set IP next-hop", but I cannot understand the purpose...
Hello,I have a task as below, but encountered an issue. Please help me.Task: Anyconnect user uses two factor authentication, Duo and ISE internal accountScenario: AAA on ASA points to Duo Proxy server and Duo Proxy server authenticates to ISE radius ...
Hello guys,I am going to upgrade Anyconnect client software on FTD using FMC.My question is when the anyconnect client software is uploaded, what happens?- Is anyconnect client software on user side going to be upgraded automatically?- Should user go...
MPLS Cedge can ping to controller (vmange, vbond, vsmart) through INET Cedge.L0 is not yet used. Just interface between MPLS and INET Cedges with physical interface.That is why branch cannot access controllers through DC MPLS Cedge=> DC INET Cedge =>...
Thank you for your help.Do you mean just add loopback to VPN 0? Hum.. Hope you can provide little more explanation.My config is INET cedge has TLOC extension for MPLS cedge.MPLS cedge has TLOC for INET cedge.INET cedge has NAT enabled for MPLS cedge ...
Hello Rob, I have updated from anyconnect 4.7 to 4.9, but when I reconnect anyconnect vpn, it does not reinstall or update anyconnect client software. my anyconnect software version is still 4.7.Any idea?
