Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,Im new to PIX Firewalls so pls bare with me.i would like to get 2 external IP numbers pointing to the same internal IP address. Now i know this can be done via port mapping but im having a little bit of trouble getting it working correctly....
Hi im trying to enable port 3101 on my pix firewall. This is the command im typing"access-list INSIDE permit tcp host 193.109.81.33 eq 3101"But it's telling me "missing command argument(s)" so obviously im missing something out. Could someone plea...
hi,im a newbie to using a pix firewall and i would like someone to help point me in the right direction? I need to enable port 3101 for my blackberry server. I have the enable password for the pix firewall but a bit stuck with where to go now. Tir...
thanks for the reply Leo.so just to double check this is what i sould be typing?1. make sure that there is an access-list for both internal address going to the correct ports2. Run below command to remove old static routes.no static (inside,outside...
when i add in this command it stops everyone getting out on to the internet through my isa server. I ran these command using the conf t command so i just reset the firewall and everything was ok after the reset. My the way im very new to using pix ...
My inside ACL is called inside. Is this correct? im typingaccess-list inside permit tcp host x.x.x.x eq 3101x=my BB server's IP addressLike i said im very new to cisco so apologise if im asking a very simple question.thanks
