Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I have an Aironet 1840i and I want to measure some signal properties such as RSSI, noise and SNR through the controller commandline. I found some documents suggesting show commands with cleanair, but those don't work since 1840i is utilizing a qc...
Hi. I have borrowed an AIR-AP1840I-E-K9 access point to perform some tests on radio signals so I'm not that familiar with the configuration of this access point. It used to work fine and the DHCP would assign an IP address to my PC as it should, but ...
Right now, I'm only after the commands that can output the shown values in console. I'm not doing a wide research on the subject, just testing out a few use cases and need to see the results that will appear in the GUI as console cmdline outputs.
I appreciate the response, Scott, but at this point my task is to find out how to get those values through commandline so that I can save them more easily.
Hi, Scott. I'm performing some tests involving other BLE devices working at the 2.4 GHz band that may have an effect on the WiFi. In the GUI it's possible to see some SNR and RSSI values belonging to the access point itself. How about those? Do you k...
Hi, Leo. Thank you for the response. Here is the boot-up process:SpoilerBoard type: AP1840Ismem ram ptable found: ver: 1 len: 3U-Boot 2012.07 (btldr release 51) (Oct 29 2019 - 06:43:09)This product contains some software licensed under the"GNU Genera...
