Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I have setup a pix 515e with 7.0.(6) I am unable to ping to the internet from the internal hosts. I am able to browse the internet and do DNS lookups. Also the hitcnt does not increment. It always shows up as 0 I have added the following line...
Gents,I am trying to setup a eazyvpn hardware client from a Cisco 837 router(Remote site) to a Cisco PIX 6.3(Central site)I am unable to setup the tunnel for some reason. I have checked and rechecked the vpn config at both ends and they match. As a t...
Is it possible to use both; hostname or ip address while trying to setup an ipsec tunnel?The scenario we have is that there is a customer who has one central site and 10 remote sites. Each site exists for a period of 3 to 6 months and then the staff ...
Hi guys,I am reconfiguring a pix 515E firewall. I came across a couple of entries such as:name 192.168.1.1 Server1name 192.168.1.0 internal networkThe first entry suggests a host name. I am not clear what the second entry means. Would the second entr...
Hi,I have setup a VPN tunnel between a 515E & an 857 router. The tunnel is established via the internet and hosts on both ends can ping each other. The 515E is the hub device. All sites connect to this firewall. The 857 router is placed at a remote s...
In short this means that there are two ways of specifying a subnet1. through the name command2. by creating a network object Am i right in my understanding?
My understanding is that access-list 101 forces all traffic destined for network 10.112.1.0 through the IPsec tunnel and the rest is allowed to go to the internet. The router is configured for split tunnel. Internet traffic is not routed through the ...
