About davef2000

davef2000 · 07-10-2006

I have a 2610 router connected to 2 networks via ethernet 0/0 and ethernet 1/0 and I have a problem with one access-list. Both networks are connected via switches and there is a DSL router on one switchport with the ip address that is the default ga...

davef2000 · 07-12-2006

I solved the problem.I needed to add a permit UDP (local network) any to access-list 171 to allow routing communications.I am using rip-2 and I believe it uses udp.Dave Fitzpatrick

davef2000 · 07-12-2006

I have minimized the offending access-list 171 to:access-list 171 permit tcp any anywhen I apply it to e1/0:config tint e1/0ip access-group 171 inIt works for 15 or 20 minutes, shows 2 matches, and then stops. No longer can get through router. This i...

davef2000 · 07-11-2006

It is version 12. I have tried this on two routers, a 2611 and a 2610. I will check if they are the same version. Meanwhile I am going to try minimizing the offending access list down to permit any any if need be and see if it is the access-list or t...

Member Since	‎07-10-2006 11:27 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	4

User Statistics

User Activity

2611 access-list problem

Re: 2611 access-list problem

Re: 2611 access-list problem

Re: 2611 access-list problem