Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Could anyone help me with a configuration for a Cisco 837 router and a Cisco PIX 501, while getting only one IP address from the ISP, because of the use of ADSL as connection?Must I configure the 837 router as a bridge by entering "no ip routin...
If you're concerned about the security hole while split-tunneling, then you have the possibility of using no split-tunneling and browse the Internet via the inside LAN, only if there is an proxyserver to connect to.The use of split-tunneling is there...
Thanks for your reply!I understand what you mean; natting on the router and not on the PIX.My goal however is to spoof the public IP from the router to the PIX and let the PIX be the termination point for VPN (PPTP and VPN client), and also configuri...
Hi,Maybe this will explain better?The hostname of the router is used to identify the router to another router when sending Challenge Handshake Authentication Protocol (CHAP) messages.The username command is required when used to specify the CHAP secr...
Hi,Ofcourse you can authenticate your users through domainnames!You can make use of CiscoSecure ACS (installed on a W2k server), a TACACS+ based application with the capability to authenticate users from your domain.Furthermore, when a user wants to ...
