About MikePenzu

MikePenzu · 09-25-2020

I have some Cisco Aironet 1700 APs (AIR-CAP1702i-E-K9) I'm trying to add to my LAN, however I'm unable to connect and configure them by every method I have tried. I can see the APs connect to the main switch and are assigned an IP address via DHCP. H...

MikePenzu · 10-08-2020

Just circling back on this thread to post my solution. The two problems I had were: 1. The access point was in lightweight mode, and needed to have the autonomous image flashed2. The original terminal cable I bought wasn't compatible with the AP To s...

MikePenzu · 09-25-2020

Oh interesting. I do see "CAP" on the back of the AP. Guess that means I need to replace the firmware... I googled and found an article about replacing the image with the autonomous version via the mode button so I will try that (once I'm able to tra...

MikePenzu · 09-25-2020

Hi, thanks for the quick reply Scott. There's literally no output at all so that makes this situation difficult to diagnose. However the fact that this AP has a console port directly on it makes me believe that it's not a lightweight AP. At least acc...

Member Since	‎09-25-2020 08:27 AM
Date Last Visited	‎10-11-2020 10:53 AM
Posts	4

User Statistics

User Activity

Unable to configure Aironet 1700 AP

Re: Unable to configure Aironet 1700 AP

Re: Unable to configure Aironet 1700 AP

Re: Unable to configure Aironet 1700 AP