Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WLC 4400 running ver 3.2.150.6. The LAP is a 1242AG-A-K9. I am getting this error message on the wireless controller log when I try and use my Symbol 9060 RF units the message is: WEP Key decrypt error. Station MAC Address is 00:a0:f8:b...
When I try and configure more than one dynamic interface I lose the ability to use the GUI. I can continue to use the console port and finnish the configs of the interfaces and WLANS and they work fine as clients can use them but the GUI is down. Tr...
Cisco is saying the WEP error is a known bug and its a fake message, so that is probably not what is causing the drops. When the clients first started dropping I also noticed another error message but it hasnt show back up till today when i put more...
I am seeing the exact same issue using Symbol 9060 RF guns. The fat AP's dont have an issue at all but when i try and use the LAP and WLC 4400 it gives the WEP error. The clients randomly drop and have to be reset with a warm boot to get them back ...
you seemed to have nailed it with the conflict of vlans containing both wired and WIFI clients. As soon as I set up a seperate interface and configured it for a vlan without wired clients the GUI via the mangement interface continues to be accessabl...
Ver 3.2.78. As soon as I apply the interface through the GUI and then try to access any other function. If I delete the newly created interface through a console session the GUI comes right back. I dont have any ACL setup that i know of.
