Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have inherited a used Cisco Css 11000 from a friend. I am trying to set up a test environment to get a jump on my classes this upcoming semester. So far I have had no problems setting it up to load balance connections between four "servers". But i ...
Does anyone know of any known conflicts between site to site and remotes? I had a remote vpn setup on my pix and added a site to site the other night and now my remote users are having problems with their vpn's. They can initiate a tunnel but cannot ...
I am setting up a remote vpn connection for some of my users to connect to our shared servers from home. The internal network on the trusted side of the firewall is 10.0.6.0/24. When i setup the remote vpn to give vpn users Ip addresses from this ran...
I am setting up a site to site VPN between two identical PIXs. My only worry is with the Nat statements in the example. In the current config all that there is listed for Nat is "nat (inside) 0 0.0.0.0 0.0.0.0" and there are a few static routes setup...
here is the confCSS11050# sh run!Generated on 07/31/2007 10:10:48!Active version: ap0500605configure!*************************** GLOBAL *************************** restrict ftp username test des-password xxxxxxxx superuser arp timeout 60 arp wait...
hey i tired to do what you suggested and i still cannot connect through the vpn. Well i can connect but i cannot access anything behind the firewall. Do you know of anywhere i can find a walkthrough to help me with this.Thank You
here is the example of the code that Cisco said to input to config site-to-site vpn. Both of my firewall confs are almost identical.hostname NewYorkisakmp enable outsideisakmp policy 9 authentication pre-shareisakmp policy 9 encrypt 3descrypto isakmp...
