Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have 2 PIX 525 running version 7.2(1). I have it setup a serial cable failover. The problem is when I run a show fail command it list that the outside interface is up and running and failover is working fine. but on the other 2 interfaces, ...
Hello, Is version 6.1 ever going to be compatable with IDS 4215? I am currently on 6.0(5)E2 and when I use the new IME I am not able to use a lot of the functionality because I am not version 6.1. Also the link they provide under the configuration ...
Hello - I am trying to upgrade my IPS 4215 to IPS-K9-6.1-1-E2.pkg file and I can't seem to get the upgrde to start. I have tried the following command from both my PC and the TFPT server. upgrade ftp://user@198.233.24.205//TFTP-Root/IPS-K9-6.1-1-E2.p...
Hello - I am trying to setup ASDM on a PIX 525. The problem is that there is an old asdm image file in flash that is not combatible with the pix software version(7.2(1)). Also there is not enough room on flash to have 2 asdm image files. So I need to...
ok, I figured out the problem I needed to switch ports in the command from 21 to 22. I have another question - since version 6.1 is not supported on the IDS 4215, when I click on configuration tab in the new IME it says that I must be on version 6.1 ...
Okay, it seems like the IPS is communicating with the router because when I look at the router I see the IDS ACL. There is still a problem though, the router sits in front of the IPS and once the sig fires the host is added to the ACL on the router. ...
Once the host was added to the ACL I was receiving alerts 10-20 minutes after the fact. When you setup a router for the IPS to manage and you put in all of the login, IP and ACL info. Is there anything you have to do to make the ACL active on the ro...
