Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok, I am trying to have an FTP server (eFTP if it matters) in my web dmz. Basically have the server with a private performing NAT to a public address, no big deal, I have enabled the appropriate port for forwarding (21) - and I can set what other po...
Hello all, I am hoping someone can shed some light on this for me. I am trying to set up multiple vlans on my pix box, i.e. vlan2 for subinterface e1.1 and vlan3 for subinterface vlan3. The pix keeps telling me that I need to add a failover license...
do a sho mem and sho flash command, you should see under the sho mem how much you have left, also I run the 7.21 and the asdm 5.1, here is my output. Can you do a simple erase? Just back it up first if you are leary....however during the install of...
Apparently what I was experiencing is a bug that appears when you upgrade to 7.x. In case you care here is the bug number and you can use the tool to look it up - either way it is purely cosmetic.BUG - CSCsc23718>mike elliott
Hi Gary,Were you running PDM or ASDM previously? Either way since you are running 7.x you need 5.x, I assume you have that on hand? Install as you would the ios via tftp with the command, copy tftp flash:pdm (i used the pdm b/c i had v3.0 initiall...
actually it is activated with the license key (activation key), so you can't turn it on/off without the proper license, if you try the error of "command requires failover license" appears.
