Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I’m not a networking expert so wondering if some one can help with an issue I have got.Device is a “Cisco SG300-20 gigabit managed switch” On this switch we have a VLAN’s set up and one of them is dedicated to external internet traffic. Like a DMZWe ...
Finally found some down time to restart the switch. It actually did the trick. Now I can change the VLANs while the switch is still up so looks like it just needed a little reset of some sort. Thank you for your assistance - Much appreciated.
Port 6 didn’t work either.I actually activated port 6 thinking port 5 may be dead, got the same result with that too.Does the switch need a reboot for settings to take effect ?Thanks for taking the time to look in to this.
