Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day all, as the command says we are using a Cisco pix 506 firewall, i've had some issues before where it would not save the configuration after i made a change, i.e. if the firewall is rebooted.I had an issue today and had to reboot the firewal...
I recently had an issue with out PIX 506 firewall, i had to do a reload which seems to have sorted the issue.One of the problems i had with this firewall is that it never saved any info after i would configure it, so.e.g. i'd use the command username...
You have to forgive me but i am a very basic cisco user, but i think the prompt is config, usually i type config -t and from there i type ' username john password password ', is it fairly easy to upgrade the device?
Good morning Vibhor, sorry about that i did not copy and paste properly, please see below for the complete output, is there something I'm missing? Cisco PIX Firewall Version 6.3(5)Cisco PIX Device Manager Version 3.0(4)Compiled on Thu 04-Aug-05 21:40...
