Good day all, as the command says we are using a Cisco pix 506 firewall, i've had some issues before where it would not save the configuration after i made a change, i.e. if the firewall is rebooted.
I had an issue today and had to reboot the firewall, now the username command is missing, so i can't add any users right now, can anyone help? Below is a list of commands i currently have.
arp Change or view arp table, set arp timeout value, view statistic
capture Capture inbound and outbound packets on one or more interfaces
configure Configure from terminal
copy Copy image or PDM file from TFTP server into flash.
cpu Display cpu usage and cpu profiling operations
debug Debug packets or ICMP tracings through the PIX Firewall.
disable Exit from privileged mode
eeprom show or reprogram the 525 onboard i82559 devices
flashfs Show, destroy, or preserve filesystem information
help Help list
kill Terminate a telnet session
logout Exit from current user profile, and to unprivileged mode
logging Clear syslog entries from the internal buffer
memory System memory utilization
pager Control page length for pagination
passwd Change Telnet console access password
ping Test connectivity from specified interface to <ip>
quit Quit from the current mode, end configuration or logout
reload Halt and reload system
shun Manages the filtering of packets from undesired hosts
who Show active administration sessions on PIX
write Write config to net, flash, floppy, or terminal, or erase flash
