Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Stumped on this one, wonder if anyone has seen it?Have a PIX 525 running version 6.1.4 and doing some STATIC translations for a small subnet of 10.50.x.x range on my outside interface inbound for 144.45.184.x (internal IP range). The 10.50.x.x range...
Presently we have two DNS appliances at two different locations behind two PIXes (520, 525). Both of these PIXes are NATed to two different external IP addresses out on the Internet. Were trying to do DNS zone transfers between the two boxes and al...
I have a request from Fleet support users to open up UDP 500/10000 for IPSEC access from a Banks VPN Dialer Software (using Cisco VPN Client Software and SofToken II), to connect to this bank's VPN Concentrator. My question is is there a way I can...
From the static syntax it shows:(internal interface,external interface) (global IP) (local IP)and yes 10.50.x.x is the global address I'm trying to translate to my internal address (144.45.184.x)
We've got pings turned off so that won't help...While I had a support person for the DNS appliances on the phone we were able to get root access to the box and try to telnet port 53 to the other box and that failed...The syslog from the DNS appliance...
The hitcounts on both PIXes still show zero hits for the rules which I have open (TCP and UDP 53) although my rules to allow DNS inquiries in from the outside world works fine on both machines (have different zones in both places, and each is the sec...
