Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thank you very much for your answer! I use ISE 2.7 and I don't know in 1.3 because there are quite big differences.In MDP I can add a device based on the MAC address, but the device status is still pending
Hello,THANK YOU VERY MUCH FOR YOUR ANSWER ! Excuse me. I asked the wrong question.I connect some controller/device to the switch, I know its MAC address and I want a specific user to be able to let this device into the network so that it will go int...
