About magic

magic · 12-06-2020

Hi, I tried to configure 3 VLANs each with own SSID but unsuccessfully. Here is my network setup:- 2 AIR-CAP2702E-A-K9 all in autonomous mode;- SG500-52P switch to which both access points are connected;- additional router (DHCP, internet gateway).I...

magic · 12-07-2020

Eventually I could change switch functionality to router mode, as it is supported as well, and utilize this device as L2 device to sort out VLAN communication.

magic · 12-07-2020

That would explain why it didn't work so far. Thanks for explaining. What if I used the switch to which access points and the router are connected and shift DHCP service there? That should work then... Of course by assigning specific switch ports I c...

magic · 12-07-2020

The router I have is Tp-link TD-W8970, it doesn't support VLANs but it does support multiple SSIDs. Also, devices from VLAN v2 do not communicate with each other (no ping response), they were connected to the AP. /Magic

magic · 12-07-2020

Access Points are connected to switch which is setup in trunk mode, it has the same VLANs configured as the APs. The router provides only DHCP service and is internet gateway. The issue is that devices connected to AP's WLAN are not communicating wit...

magic · 12-07-2020

I have attached Access Point config file, I hope it will help to identify fix for the issue.

Member Since	‎12-06-2020 02:14 AM
Date Last Visited	‎09-30-2024 01:48 PM
Posts	9

User Statistics

User Activity

Aironet 2702 setting VLANs with individual SSIDs

Re: Aironet 2702 setting VLANs with individual SSIDs

Re: Aironet 2702 setting VLANs with individual SSIDs

Re: Aironet 2702 setting VLANs with individual SSIDs

Re: Aironet 2702 setting VLANs with individual SSIDs

Re: Aironet 2702 setting VLANs with individual SSIDs