Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am a student at an academy and I messed up my router... When trying to change the configuration registry, I accidentally entered 0x2132However, before I could fix it I had to leave. The next day, the router no longer responded to hyperterminal....
HiUpdate: I pulled the flash out and booted it up into rommon. I then set the confreg as 0x2142. When I put the flash back in and boot it up, its fine. But if I attempt to change the registry back to 0x2102 and reload it, the registry changes back to...
Ok, so I set the baud rate to 1200, and I was able to talk to the router again. However, when I tried to change the config registry back to 0x2102 it does not work. I change it, then I reload the router. The router still loads up as 0x3102, I am not ...
