Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
m-haddadI followed your instruction and it booted upthe ACT LED is on.Thank you so much.Now that the outside interface Ip has changed (due to location change) would it sufice to Issue the address command with the new Ip?
I opened the box and everything is intact.I truned on the device and I see same thing on the terminal.However,ACT is still off. here is what I see on the terminal--PCI Device Table.Bus Dev Func VendID DevID Class Irq 00 00 00 8086 ...
ACT LED is offNetwork LED BlinksPower LED is ONPing fails.The PCI Device Table starts listing on the terminal but somehow stops around the Ethernet details.
I installed SecuredCRT and did the config9600 N stop bit 1. I am still getting same thing. That is part of the PCI Device Table is displayed and the cursor just blinks. We just moved to a new location with the new outside interface IP given from ISP....
