About steve.goldman

steve.goldman · 10-10-2006

You'll have to excuse me, for I'm quite new at this. Our company just purchased an 1811 integrated services router that has two wan ports. I would like to configure the router to support one local LAN subnet with NAT and failover on the two WAN por...

steve.goldman · 11-30-2007

My access lists are pretty long and specific to my setup. There really isn't much playing that has to be done. Just make sure that each service is represented on the access lists. There should be two separate lists. One that provides access on th...

steve.goldman · 11-30-2007

Okay, now I see what you're saying. I may have left these lines out of the sample I attached to my previous post. These lines setup the static NAT for both lines.===============================ip nat inside source route-map FAST-0 interface FastEth...

steve.goldman · 11-30-2007

This IS Steve Goldman. The same that made the previous posts.I am using 1 to 1 NAT translations as well which uses a setup with two separate access lists, one for FE 1 and one for FE 0. Both contain the entry:access-list ### permit gre any anyWe th...

steve.goldman · 11-30-2007

I believe the relevant portion of the config is contained in the attached txt. If there is anything missing, I hope someone will correct. This was taking from our working 1811 with failover.In our case, this is setup to check FE-0 and failover to F...

steve.goldman · 10-26-2006

This is precisely what I'm trying to achieve. What complicates it further for us is that we're also trying to use NAT with publicly accessible servers behind the NAT. I would have to allow port forwarding. Now I beleive there's a way to allow for ...

Member Since	‎10-10-2006 05:42 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

NAT routing with failover on 1811

Re: NAT routing with failover on 1811

Re: NAT routing with failover on 1811

Re: NAT routing with failover on 1811

Re: NAT routing with failover on 1811

Re: NAT routing with failover on 1811