Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hiI have 2 WiSM running in virtualization mode, the AP are not able join, knowing that i am running DHCP locally on the core switch and there is no DNS server, when I checked the boot of the access point it is saying it is unable to receive vci code ...
HelloI ahve 2 Cisco Wism installed on 6506-E running virtualization. when I run show wism status, the controllers are unable to get IP addresses for the service and mangt interface knowing the Vlan is there and local dhcp configured. wism service com...
GentsI configured an autonomous access point as being a repeater to a root one. I ping the root from the repeater and it is showing as connect. however,the wireless coverage has not been extended?what is the problem?
GentsI 2 WISMs and 2 4402 controllers. the WiSM are the foreign controllers and the 4402 are my anchor controllers. I am trying to add them to the WCS for management purposes. however, I am not able. knowing that I have ICMP reachability between all ...
Guys the problem is solved and it was an error in the DHCP configuration on the core switches. there were missing 0 in the address and error in conversion between the decimal and hexadecimal base.Thanks,Elie
Guys, I noticed sthg that the user is connecting to the farthest access point and not the nearest one to the him. How to control that and why this behavior?
