About ciscoathome

ciscoathome · 10-24-2006

My understanding is that the noise level in a WLAN is a result of the environment where wireless equipment is in use.I have a site where the noise is around -98 dB when connected to an AP with the speed fixed on 11Mb. But when I connect to another AP...

ciscoathome · 10-25-2006

I have seen PCMCIA to USB adapters but I think they need to be cutom made for each type of PCMCIA card. Does anyone know of a suitable adapter?

ciscoathome · 10-25-2006

I've done some testing in a live environment where we varied the antenna gain from 0 to 5 to 10 for a dipole antenna whose gain is 5.2. There was a difference in the cell size at each setting but it was not consistent around the whole cell and really...

ciscoathome · 10-25-2006

The UPS is a good idea except for the weight. The other problem is that UPS batteries are not designed for continual charging and dis-charging. You will shorten the life of the batteries using them this way. However, it still may be the best way to g...

ciscoathome · 10-25-2006

I experienced a similar issue and always used the 2nd PCMCIA slot, but after a HDD crash and complete rebuild I found the first slot worked. This suggests the drivers for the first slot were faulty. Try replacing the drivers for the faulty slot.

ciscoathome · 10-25-2006

I assume you are doing an active survey and associating with a particular SSID. AirMagnet won't roam from one AP to another until the signal strength drops to a very low level. If you want to associate with a particluar AP, then click on the drop dow...

Member Since	‎10-24-2006 08:33 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	8
Total Helpful Votes Received	6

User Statistics

User Activity

Noise level increase with speed

Re: Site survey on non cisco card

Re: Antenna gain setup with 1310

Re: Aironet site survey battery packs - UK

Re: Scan not picking up AP

Re: Airmagnet Surveyor Active Survey