Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a flat network and would like to segment my newtork into 5 or 6 ???? subnetworks. I have about 150 clients and about 10 servers. Which would be an adequate router for doing this? Someone told me a 2851 could do the job???? Any ideas guys?
I have a PIX 501 i need to configure and need some help. The address of my inside netork is 192.168.0.0 and the outside will be 192.168.1.0. I have been able to assign ip address to the inside interface as 192.168.0.35 and the outside interface as 19...
Currently the whole building is on one network. I want to segment this network. I have a Cisco 1841 Router just sitting here. Can anyone recommend the best way to do this? The building is split into 3 levels with clients on each level connecting to ...
Thanks for the response josephdoherty but I think you didn't get the question i was asking since all you mentioned in your response were switches. The answer I was looking for was for a router model. Like i said i have a flat network and would like t...
Ok guys i get all what you are saying but I think it would still be nice if you guys could give me a direct answer on who i could do the segmentation and a list of what all i would need. This would be of help to me since I need to do a report and sta...
