Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm a novice to the Cisco RV345 router, so bare with me. I recently placed an RV345 into my network environment in preparation for a dual-WAN setup. Originally our setup was very straight forward and everything -- both hardwire and wireless -- was be...
Hello, I recently made the switch from Peplink Balance 20 to Cisco RV345. On the Peplink I could do Policy Based Routing by MAC address and force certain machines through a specific WAN. On the RV345 I only seem to be able to do this by IP address. I...
@Georg Pauwen and @paul driver, Well, the test bench setup was very helpful as it told me that the RV345 really wasn't the problem. I put the RV345 back into my network and reconfigured the Orbi AX6000 into access point mode again and the Echo device...
Guys, Here is something interesting. I factory reset the RV345 this morning. Then created a little test bench setup using another Orbi system that we have and my back-up 4G LTE modem for ISP connectivity. The only changes I made to the RV345 after fa...
Hi @Georg Pauwen and @paul driver , Actually, I did try disabling the firewall all together and I had UPnP enabled at one point. Unfortunately I've tried so many different combinations I've started to lose track now. I'll see if I can diagram things ...
@paul driver, all devices were working properly before making the change to the RV345. If I take the RV345 out of the mix and put everything back to just the AX6000 as the default router then they are fine. As soon as I put the AX6000 back to access ...
