Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am getting input que drops on cisco 3845 router gig interface. I have verified the physical layer connectivity. It is fine. CEF is enabled on the other end of the switch. What needs to be done to minimize the errors
Hi, We have a router with two subnetworks 10.125.x.x/19 and 10.118.x.x/22 configured on the same interface one as primaryip and the other as secondary. And these two subnetworks are connected to LAN through 2950 switch. In the switch there are no vla...
Hi Matin, Thanks for your response. Please find the interface config.dcnrtr1#sh int gi 0/0GigabitEthernet0/0 is up, line protocol is up Hardware is BCM1125 Internal MAC, address is xxxx.xxxx.xxxx.xxxx Description: Native_VLAN MTU 1500 bytes, BW 10...
Hi Anand,IP addresses primary and secondary are mentioned on router not on switch. It is L2 Switch. Router ip address is 10.125.96.1 primary and 10.118.224.1 secondary. Now i am able to communicate both the networks. My new question is if any of the ...
