Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, From the outside, can you ping the nexthop ip address, which should be directly connected to fa0/0 of your 2600 router? If not it's not likely a problem on your 2600 router. From your 2600 can you ping your nexthop ip address off fa0/0? Can you p...
Hello Caligula, Impossible to tell you what the root cause is. May or maynot be the GBIC. However, i have the following couple of suggestions:1. Try to avoid configuring channels with mode ON/ON on both sides. Instead try to use, DESIRABLE/DESIRABLE....
Alex, I'm not clear about your question. I'm not sure if your asking if the 4507R needs 0/0 route (gateway of last resort) or a default gateway as a normal layer 2 only switch would. Nevertheless, if you have enabled routing on the switch, then you w...
Hello there, Based on your comments, the reason why this is not critical is because the backup saturates your link during non business times. In which case this is clearly not a problem for you in most circumstances. I assume you anticipate this may ...
You will probably also need the command""switchport mode trunk"under the 2950 switchport interface.Have a look at:http://www.cisco.com/en/US/partner/products/hw/switches/ps628/products_configuration_guide_chapter09186a0080212c3e.html#wp1200245Bill.
