Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there - I'm a beginner to Cisco products, but have bought an 1830 series AP and am trying to convert it to autonomous mode. When I plug it in using the POE injector (with 'To Switch' going to my router, and to AP going to the Access Point), it b...
Thanks again :). So from some more reading & trial and error, I figured out I had to type 'en' and enter the Cisco password to get into config more; after this I was able to get a fair bit further, and at least run the command to download the new i...
Thanks very much for all your help. I ended up going out to buy a Console cable (USB > RJ45) and seem to have successfully connected to the AP - when I do 'sh version', I get the following: Cisco AP Software, (ap1g4), [cheetah-build5:/san/BUILD/wo...
Thanks so much for the reply, Rasika I've just read this through again, but after startup, the LEDs on the AP are flashing Green, Red & Amber, which seems to suggest that 'Discovery/join progress is in progress', whereas the article suggests it sho...
