I have connected two 2600 routers back to back using DTE/DCE cable. I have set the clock rate 56000 at DCE end. I have also assinged IP addresses to the Serial interfaces. But when I connect them I get this message 'serial is down line protocol is do...

Is it possible to communicate between two 2600 router using WIC-2T without using CSU/DSU.When I install WIC-2T I get this errorSlot is empty or does not support clock participate WIC slot is empty or does not support clock participate

HiI am trying to install WIC-2T card on two cisco routers so that I can communicate between them using DTE/DCE serial cable. Can someone guide me/ThanksMoazzam

Hi I initiallly configured 2600 cisco router. And than I installed WIC-2T card. It installed perfectly fine. But now when I amd trying to access the router using hyperterminal I get this error and I cannot go to the command line "Slot is empty or doe...

I have to connect two cisco 2600 routers using wic-2t serial card. What kind of serial cable i need. Can someone give me the specs and links to vendors. I would really appreciate the help