Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I got some problems with DHCP relay, I hope somone can help me out! I've set up the environment in my lab and get the same result:* Client (set to DHCP)* Router 1 (Cisco 871) (LAN IP-add (VLAN1): 1.1.1.1/8)* Router 2 (Cisco 871) (LAN IP-add: 3.3.3.1/...
Sure thing!Didn't get every detail of the capture since I couldn't figure out a good way of copy/paste in Ethereal. Let me know if you miss something in particular.SERVER SETTINGSDHCP Server interface 3.3.3.3IP Pool starting address 1.1.1.100Size of ...
Downgrading the router didn't help either!I also tried to shift the routers so Router1 became Router2, and Router2 got Router1's config. Far fetched, I know, but since it was an easy thing to do, I tried but the problem remains. So it's not the parti...
There is no such command as 'sh ip socket' in the 871?Service dhcp is enabled in the router. I disabled it before to see if it made any difference, but it didn't so I enabled service dhcp again.(I'll see if I can find a bit older image to use in the ...
Hi everybody!The router was shipped with 12.3(8)YI2, and since it didn't work I tried to upgrade to 12.4(6)T5 before I posted my problem here, but it made no difference. Today I followed your advice and installed yet a later version: 12.4(11)T, but t...
Hi Rick!Thanks for taking your time trying to help me! Here follows the output you requested except output from debug dhcp which showed nothing at all. I also added the output of debug ip icmp to show that the router, as mentioned in my first post, i...
