Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hopefully this is a very simple question to answer.I am using IOS ver 12.4(10b) on a 3640 router with a NM-8A/S module. When I go into the interaface configuration mode for one of the serial interfaces I cannot use and do not see the "frame-relay" c...
Once again I would like to thank you guys for your help and quick response with the issue.To resolve this issue I had to re-enter the "encapsulation frame-relay" command on my serial interafaces and made sure that I saved the running config.-Thanks
Thanks for bringing this to my attention. The "encapsulation frame-relay" comand was one of the first commands I entered when configuring the serial interfaces but when I took a second look at the config I saw otherwise. Some kind of way I did not c...
