I have a 4510 core and 3560 stacks at the edge. the mgt IP is 10.146.1.0/24, the VLANS are 10.146.x.1/24 and are assigned to each switch based on location.many of the clients attached to these switches are 192.168.x.x and obviously won't go anywhere...

I had a cluster, 4 switches in all. did a 'no cluster enable' on the command switch without removing the members. the members still think they are part of the cluster, and doing a 'no cluster enable' there results in an 'not the command switch' err...

I have used both, but am embarking on a brand new network running a 4500 series at the core and 3750's in several closets.I am relatively sure I have to run COS as we are wanting to do Dynamic VLAN's.Just wondered if there were any real reasons (besi...