Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,Due to flash inconsistency/errors after a power surge issue, my router C800 started acting very strange. Having spent several weeks trying to bring life back into it through formats and the whole lot, I decided to replace it completely. I man...
Hello, I would like to request some help with making a few changes to this router, in order to get access from outside.I have tried to do it myself but I have caused more damage than good. This is because I am honestly not at all familiar with the co...
Hi Georg,Happy New Year! Thank you for the cleaned up config. I did a write erase followed by delete vlan.switch and reload then added the config. NAT is now working again to my amazement. Added acl's and confirmed still working.
"RTR00#show ip nat" portblock dynamic global detail^% Invalid input detected at '^' marker.
RTR00#show ip natRTR00#show ip nat ?
nvi NVI informationredundancy NAT HA redundancystatistics Translation statisticstranslations Translation entries
RTR00#sh...
I added the route but no change. I am able to tracert to the addrrss but there's no reply on the ports. Two of them are for VPN and the 32400 on clients network is for a media server. Comparing the configs for the nth time, I noticed the thumbprint a...
I will add this when I have access again. I am surprised when you mention nothing should work It has been working for me this way for well over a year.
