Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco Firepower 1010 that I am trying to connect to a ubiquiti network switch that is configured for 3 vlans, default 1, 120 and 130. I have configured the same vlans on the Cisco Firepower 1010 and have setup DHCP servers for each vlan. I...
I have a RV345 running Firmware 1.0.03.20, it is intermittently restarting. I have turned on logging and I don't see any errors. I am trying to figure out why the router would reboot on its own. It happens 1 to 3 times a day. This has only become...
So I have a similar question.I have a Cisco Firepower 1010 that I am trying to connect to a ubiquiti network switch that is configured for 3 vlans, default 1, 120 and 130. I have configured the same vlans on the Cisco Firepower 1010 and have setup D...
I have a RV345 router that is intermittently rebooting too. I have logging turned on, and I don't see anything indicating what is causing the router to reboot. I am not getting any error codes, I just see a system message that the device booted wit...
