Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm new to the Cisco forums; thanks in advance for your help! I'm building the below network configuration:WAN -------- ASA5505 ------<802.1q trunk>----- L3 switch -----<802.1q trunk>----- L2 switch w/ VLAN supportThe following VLANs exist on...
I wound up running into another issue; when the ASA and L3 switch were configured with a WAN-bound traffic transport VLAN, and the switch was configured with ip route 0.0.0.0 0.0.0.0 , the L3 switch would forward self-generated WAN-bound traffic to t...
Hi Mitchell,Thanks for the reply.When you say "default gateway" are you referring to the "ip default-gateway" command? Or the gateway of last resort as the title of your discussion references (I.e. ip route 0.0.0.0)?From the perspective of the L3 swi...
Thanks for your reply.For now, the different VLANs are used for logical segregation, but I'm not enforcing any ACLs between them (with the exception of VLAN 99, which is used for management).- John
Hi Soroush,Thanks for the reply.The ASA is in routed firewall mode, and has per-VLAN virtual interfaces with the 10.10.x.2 IP address assigned to them (to distribute addresses via DHCP). The ASA is performing WAN-bound routing, but is not performing...
