Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a second internal network using interface 0/2 on the ASA. Basically, where I am at now is:ASAINTERFACE ETHERNET0/0nameif outsidesecurity-level 0ip address x.x.x.130 255.255.255.128INTERFACE ETHERNET0/1nameif insidesecurity-level...
I have a 24 port cisco switch 2924 and port 22 isn't functioning and there are no errors in any of the logs that I can see? This isn't the first time this has happened, it seems like random ports on occasion just stop working with nowhere for me to ...
Hi Julio, everything works. The only thing I change was from group 1 to 10. 10 is the group we are using for the global NAT range. Everything worked after that. Now, one last thing, I am assuming there will be no communication between the two int...
Sounds good, can you explain what that means exactly, the 1 0 0 part.Thanks for the prompt response!Also, I assume since these two internal networks are at the same security level, by default, they won't be able to contact each other, correct? I act...
No port security, show log doesn't show any errors at all on the switch, it just shows that I restarted it yesterday and that port 22 (problem port) was adminstratively down at one point, because I set it that way and tried enabling it again, but it ...
