Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
glbp will just route traffic to both routers but dis will be done on the weight u specify.for example in your sample, if one packet goes to one router about 2.5 will go to the next router. it is simply routing over un-equal path here, kind of. If u ...
mate, it will not load balance. I think mainly because you didnt tell it to load balance in the first place.You needglbp 10 load-balancing weighted on the two routers, to the best of my understanding round-robin and host-dependent will only allow u u...
Trust me on this, if u dont want to have sleepless nights and the management on ur neck. Do it in phases. If anything happens, which most likely will. Even if u have run ur pilot tests, it is only a pilot test. If it works well there, it isn't a guar...
Assuming u are goin to track http://www.cisco.com, u use this sla command first. This indicate the sla process.ip sla 1 http get http://www.cisco.comip sla schedule 1 life forever start-time nowthen u specify how u want it to be tracked.track 1 rtr 1...
Hi mate,Am new here but I hope I can help.before you decide with path to take, you must know which services and protocols you will need to support over the redundant links. For example Stateful NAT (SNAT) can make use of HSRP to fail over but it w...
