Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured 12 1522's using the 4400 controller to assign static IP addresses but they still seem to revert back to using DHCP after a time, has anyone else has this issue?
What is the best way to debug a 1522 AP which has blacklisted its preferred mesh network path back to the root access point and will instead use a very poor path? I seem to find a lot of info on blacklisted clients but not on AP's?
I will double check this today, I am sure the vi is set to 1.1.1.1 and the management and manager interfaces are untagged.Can you elaborate as to why this may cause the AP's to DHCP?Thanks for the reply.
