Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi guys, i got some prob in ASA plz help me out,, pc1-----------ASA----------pc2 outside inside now see nat is disabled and i have given an accesslist to allow pc1 to ping pc2. till here it is working fine. now suppose i have i...
hi guys, i got some prob in ASA plz help me out,, pc1-----------ASA----------pc2 outside inside now see nat is disabled and i have given an accesslist to allow pc1 to ping pc2. till here it is working fine. now suppose i have i...
hi i have 3 routers connected to a switch n only vlan 1 is to used. RA , RB , RC are 3 routers. i m running rip ( u can take igrp, eigrp but not ospf or isis) RA have 2 networks i.e 10.0.0.0/8 and 20.0.0.0/8. my task is that i want RA to only adverti...
but dont u think this is inconvenient ?? like if there are 2 outside users connected to my webserver n i want to block 1 of them so i designed an acl but if i clear xlate then both of the connections will be reset !!! is there any other way
thnks for the reply but i have tried it see, in RA config-router mode i mentioned two neighbours (config-router)# neigbour B (its ip)(config-router)# neigbour C (its ip)now in distribution list we normally use standard access list rite ? but i want t...
thanks for the response but i have already tried it, u see i want to filter updates for a SPECIFIC neighbour on a medium where other routers are also getting the updates, how can i prevent it ??? how can i do it ???
