Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!
I was trying to find a way to set up a VPN tunnel on an RV325 where the tunneled IP ranges include two non contiguous subnets. However, on the the RV325 you can only enter ip address and subnet mask. Is there any way to do it?
thanks
Tamas
hi!we have recently purchased an asa 5510 with smbsa service. Since it is our first cisco equipment, we didn't know much about thr different service offerings. (we used hardware from other vendors, but the asa seemed to be a good buy)In every documen...
Hi everyone!I have set up vpn remote tunnel from xp sp2 with easyvpn client to an asa 5510 head. The connection works from cable remotes, but not over a gprs connection.Since ping works, I assumed it might be MTU related so I kept decreasing the mtu ...
Since it seems, that no one has any ideas, I am going to try to reduce the mtu on the outside interface. I have read somewhere the mtu site does not affect the packet passing through. so does anyone know if the reduction of the mtu on the outside if ...
Thanks for helping. Yes built in the firewall is enabled, but since the config works on broadband this is probably not the cause.The problem is only over gprs so that why I thought this might be network related rather than config issueregardsTamas
