About PankajPatel1758

PankajPatel1758 · 01-21-2022

Hello, I have 2 point to point leased data circuits between two offices. These 2 links are connected to Cisco 3845 and Cisco 2811 routers WIC-2T card serial ports in both the offices. Static routing is used between these two sites and Multilink with ...

PankajPatel1758 · 01-22-2022

Hi,For some reason I have to stick to static routing only, I don't have the liberty to change it to dynamic routing.I am unable to configure primary secondary setup because I can't put the same IP address to 2 different interfaces (I believe I need t...

PankajPatel1758 · 01-22-2022

Hi, I have posted the concerned part of the configuration file.For implementing primary backup setup with administrative distance I believe I need to configure two serial ports with the same IP address in my case (which is not possible). The only way...

PankajPatel1758 · 01-22-2022

Hi, What I mean to say by saying unstable link is: It goes down for few minutes 4-5 times a day. So during those 4-5 transitions I am observing some data gaps. I didn't understand how making the port down by EEM script will help here.

PankajPatel1758 · 01-22-2022

Hi,Router-1 configuration: interface Multilink 2ip address 10.10.100.253 255.255.255.0ip pim-sparse modeppp multilinkppp multilink group 2 interface se 0/0/0no ip addressencapsulation pppppp multilinkppp multilink group 2 interface se 0/0/1no ip addr...

Member Since	‎03-09-2021 10:20 AM
Date Last Visited	‎02-01-2022 08:23 AM
Posts	5

User Statistics

User Activity

Primary and backup link setup for point to point circuits

Re: Primary and backup link setup for point to point circuits

Re: Primary and backup link setup for point to point circuits

Re: Primary and backup link setup for point to point circuits

Re: Primary and backup link setup for point to point circuits