Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hallo, im trying to create a playbook for SNMP Configurations and i need your help/suggestions. so i want to config this 4 commands for example in one run,playbook: - ios_config: lines: - " snmp-server group {{ group_name }} {{ snmp_vers...
Hello everyone, im planning to config a LACP between XR Router and QFX switch. My questions1- is my LACP connection is correct or the MUX state must be ATTACHED not DISTRIBUTING ? 2- how i can config ip address ( Gateway ) for the aggregated Inte...
Hello everyone, i configured eBGP session between IOS XRV and VMX Routers, but still the BGP state on ACTIVE. can someone help me please to solve this problem. Configurations in IOS XRV Router:!interface Loopback0ipv4 address 10.100.100.3 255.255....
Hi Seb, first thanks for your replay,HINT: im using ansible roles your solution will be good if i have only one group , but in my case i have two diff groups ( group_1 , group_2 ) is there any other solution to prevent writing the whole command ? t...
Hello @Giuseppe Larosa, thank you for your replay, i have already configured the periodic fast on FQX, but sometimes display slow and sometime fast for set ip address ( gateway ) on XR, its so correct? interface Bundle-Ether200ipv4 address 10.1...
Thank you mr Harold, its look better now. did you know how i can advertise the connected networks ( for example loopback ) on VMX side ? [edit]root@VMX1# run show bgp summary Threading mode: BGP I/OGroups: 2 Peers: 3 Down peers: 1Table ...
