Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, have a customer who is using Up Guard to scan their network and are reporting port 161 open and are concerned. Though I’m unable to see this port open from external testing and even put a FW rule into block it, they’re saying it’s still showing a...
Hello,My question is (as asked by a customer) if we have two radius servers defined for example, as follows:RADIUS serversHost Port SecretActions10.0.1.11812xxxxxxxxxxxxxx 10.0.100.11812xxxxxxxxxxxxxx Add a RADIUS serverIs there an order priority...
Hello,Fairly new to Meraki and trying to establish if there is a facility to generate some sort of report for all network in an organization as relates to a particular element. For example if I have an organisation, with say 800+ networks on it, and ...
Hello,Tried do a simple bridge of ports on an ISR4431 and got the following results:dummyroutername(config)#bridge irbdummyroutername(config)#!dummyroutername(config)#bridge 1 protocol ieee^% Invalid input detected at '^' marker.dummyroutername(confi...
Hello,Thank you for your reply but trying to block it from being able to be polled. Not to allow it.Will review my rules tomorrow however. Kind regards,Bob
Hello,Thank you for your time and reply. Yes, that’s makes perfect sense. The problem did seem to occur after AutoVPN was enabled for the AnyConnect range. I will speak to the end customer tomorrow and see which way they would like to proceed. Kind r...
Hi. Thanks for that. Seems problematic then as it indicate that regardless of whether the first address is best or not it will always be used. An issue of the second address is local to the device and the first address is a remote address from anothe...
