Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I got some issue multi authentication on Cisco 2960s switch. I need to add macro for some of ports(for clients). I cant write "authentication event server dead action authorize" and "authentication event server alive action reinitialize". Cisco s...
i hope, if i find i will share the proccess.The supplicant can be auth but It doesn't have mutli-auth mode and auth. event server dead command. For example; i can write this config and i can see supplicant on Cisco ISE.int gi0/28switchport mode acces...
I very appreciate your helping but it didnt change after the global aaa authentication. I can see on the Cisco ISE mab and dot1x authentication success with single supplicant. I tried to reset sw and again defined dot1x auth. didnt change. If i can...
there aren't any configuration on the switchports. All ports default. Commands are not listed when i write multi-auth. But i can write single-host auth. I can't think of anything else, there may be a problem with the device.
Sorry, i didnt specify int the statement. I need to configure mutli authentication on the same switchport. When device has 12.55 ios that interface didnt show me "authentication host-mode mutli-auth". and including the commands I mentioned above. I t...
