Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi team,I have c9300 connected to SRX 340 via static route. I have also VRF on this switch with vrf default route through global. the VRF has source multicast and needs to get out through global routing table. VRF config po11no switchportip vrf for...
Cisco warriors, I need help with this please!I have SRX doing proxy-arp 192.168.0.0/16 with directly connected to cat 9300 cisco I want to put another SRX in between as a layer 3 for extra security. is there a way to keep the same IP address for the...
dear Team,I have configured secondary vlan ip on sw -1vlan 11ip add 1.1.1.1/24ip add 2.2.2.1/24 secondary on sw2:vlan 14 ip add 3.3.3.1/24 switches are connected via OSPFI have a PC on vlan 11 (sw1) with secondary IP 2.2.2.2/24 2.2.2.1 2.2.2.2 is not...
any reason why my post was marked as spam? i you do not have an answer, please do not mark as spam! team,after converting from FTD to ASA, I can not get into enable mode. when I do show run, I see the interfaces and it is ASA mode, but I can not get ...
appreciate the response and article. my configs are based pretty much on the instructions in the article and still does not work. I was wondering if this is a limitation of 9300?
