Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Catalyst 3560 and when trying to assign IPs to a port (using telnet to the switch's main IP) I keep getting an error.Here is the commands as s I am trying to enter them and you can see the error I have highlighted in red below.SC-153>enab...
Hi Guys,Thanks for your help.I got the ips routed to the correct port thanks to a Linux engineer I know.I need a good tutorial on the bare basics for the most common telnet tasks. Something with examples since I'm completely new to this.Thanks again
Hi,Thanks for yoru quick reply.So the commands I need to enter would be?SC-153>enablePassword:SC-153#config tEnter configuration commands, one per line. End with CNTL/Z.SC-153(config)# interface FastEthernet0/23SC-153(config)# no switchportSC-153(co...
