Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,how can I setup that the backup connection will start but after 30s of icmp timeout the default gateway (tracket object - 192.168.1.1)My configuration:sla monitor 123 type echo protocol ipIcmpEcho 192.168.1.1 interface outside num-packets 3 fr...
Hello,I'm not sure how does the SLA monitoring works...Example:sla monitor 123
type echo protocol ipIcmpEcho 10.0.0.1 interface outside
num-packets 3
frequency 10!--- Configure a new monitoring process with the ID 123. Specify the
!--- monitoring...
Hello guys,I have problem with dual ISP + IPSEC on my cisco ASA5505 sec plus licence.Routing is working correct (connect to Internet from siteA is working trought1st also second ISP) but IPSEC is working just trought the firstISP! It seemt that phase...
thanks for your answer but it doesn't solve my problem because my primary line has sometimes packetlossand than the backup still comes on but I don't wont it because the switching between primary and secondaryline is worse for me than sometime lose a...
Hi Mike,it was just a piece of full sla configuration I know, it was just for example...I have full configuration and it's working but i dont know how exactly.Therefore i have some questions:When does the routing table change the default route in upp...
I found the problem but dont know how to fix it now!Problem is on siteB with using the same ACL name "siteA" in both sequence numbers in cryptomap "outside_map"crypto map outside_map 9 match address SiteAcrypto map outside_map 9 set peer 212.89.229.x...
